Shop
4 Channel Infrared Tracking Module
160,00 EGP- Working voltage (V): 3.3 ~ 5
- Working current (A): Above 1A
- Operating Temperature (℃): -10 ~ +50
- Mounting hole: M3
- Detection range: 1mm ~ 60 cm adjustable.
-13% 
-13% OFF
4-Pin Light-Dependent Photosensitive Sensor LDR Module
Original price was: 40,00 EGP.35,00 EGPCurrent price is: 35,00 EGP.4-pin LDR photosensitive sensor module with adjustable light detection sensitivity.
New
4-Way Arcade Joystick for DIY Arcade Sticks
260,00 EGP4-Way Arcade Joystick
1. Type: Mechanical Arcade Joystick
2. Directions: 4-Way (Up / Down / Left / Right)
3. Switch Type: Microswitch-based
4. Mounting: Panel mount
5. Use: DIY arcade sticks & custom controllers
4.7k ohm 1/4 Watt
0,25 EGP✅ 4.7K ohm resistor
✅ 0.25 watt power rating
✅ Through-hole axial leaded package
✅ Suitable for low-power electronics
4.7uF 50V Radial Electrolytic Capacitor
1,00 EGP- ⚡ 4.7µF radial electrolytic capacitor
- 🔋 Rated voltage: 50V for reliable DC filtering
- 🧩 Ideal for power smoothing, decoupling, and timing circuits
- 🛠️ Through-hole radial leads—easy soldering on PCBs
- 📈 Helps reduce ripple and noise in power lines
- 📦 Compact size for general electronics projects
- 🔧 Common choice for repairs and prototyping
- ✅ Suitable for Arduino/analog/power supply circuits
New
4×4 Matrix Keypad
35,00 EGP- Ultra-thin design & adhesive backing provides easy integration to any project
- Excellent price-performance ratio
- Easy communication with any microcontroller
- 5 pins 2.54mm pitch connector, 4x 4type 16 keys.
- Sticker can peel off for adhesive mounting.
- Operating Voltage (V): 12 DC
433MHz HC-12 Wireless Serial Port Module (1000m Range)
275,00 EGP- Compact, low-power 433MHz RF transceiver.
- Transparent TTL UART (serial) interface — plug & play.
- Long range: up to 1000 m line-of-sight (with suitable antenna).
- Configurable via AT commands (baud rate, channel, power, mode).
- Wide operating voltage for direct microcontroller connection.
- Low standby/operating current — suitable for battery systems.
- Reliable data link for telemetry, remote control, and sensor networks.
470 ohm 1/4 Watt
0,25 EGP- 🧰 Resistor set: 470Ω (1/4W) – 4 pieces
- ⚡ Power rating: 0.25W for general-purpose electronics
- 💡 Great for LED current limiting and indicator circuits
- 🧩 Useful for pull-up/pull-down and signal conditioning
- 🛠️ Through-hole type—easy breadboarding and soldering
- 📦 Pack of 4 pieces—handy for DIY and repairs
- 🔧 Common value for Arduino and prototyping projects
- ✅ Reliable resistors for everyday circuit building
470uF 25V Radial Electrolytic Capacitor
2,00 EGP470uF 25V Radial Electrolytic Capacitor
1. Capacitance: 470µF
2. Voltage Rating: 25V DC
3. Capacitance Tolerance: ±20% (typical)
4. Mounting Type: Through-Hole Radial
5. Operating Temperature: -40°C to +85°C
6. Polarity: Polarized (marked case)
470uF 35V Radial Electrolytic Capacitor
3,00 EGP- ⚡ 470µF radial electrolytic capacitor
- 🔋 Rated voltage: 35V for power filtering and smoothing
- 🧩 Ideal for DC power supplies, amplifiers, and motor circuits
- 🛠️ Through-hole radial leads for easy PCB soldering
- 📈 Helps reduce ripple, noise, and voltage dips
- 📦 Common value for repairs and electronics prototyping
- 🔧 Suitable for decoupling and bulk energy storage
- ✅ Great for Arduino and general electronics projects
47uF 50V Radial Electrolytic Capacitor
1,25 EGP- ⚡ 47µF radial electrolytic capacitor
- 🔋 Rated voltage: 50V for reliable power filtering
- 🧩 Ideal for smoothing, decoupling, and timing circuits
- 🛠️ Through-hole radial leads for easy PCB soldering
- 📈 Helps reduce ripple, noise, and voltage fluctuations
- 📦 Common value for repairs and prototyping
- 🔧 Suitable for power supplies, amplifiers, and control boards
- ✅ Great for general electronics and DIY projects
4A Single-Phase Diode Bridge Rectifier (1000V, Through-Hole)
9,00 EGP- 4A Current Rating: Suitable for moderate power AC to DC conversion
- Wide Voltage Range: Typically supports up to 1000V reverse voltage
- Full-Wave Rectification: Converts AC input to smooth DC output
- Compact & Reliable: Ideal for power supplies and DIY electronics
- Easy to Mount: Standard 4-pin configuration for simple PCB integration
Recently Viewed Products
Ekostra Electronics | Microcontrollers, Sensors & 3D Printing Supplies
Shop top-quality Arduino, ESP32 & hardware in Egypt. Build your DIY and engineering projects with fast local shipping and cash on delivery.
